LED 7-Segment 0.56 inch Red Common-Anode
--------------------------------------------------------------
LED molding package: put the pressed and welded LED 5161BS support into the mold, use the hydraulic press to close the mold and vacuum the upper and lower molds, put the solid epoxy into the inlet of the glue channel, heat it with the hydraulic push rod and press it into the mold glue channel, and then the epoxy goes into each LED forming groove along the glue channel and solidifies. 5161BS LED curing and after curing, curing refers to encapsulating epoxy curing, general epoxy curing condition at 135 ℃, 1 hour. Moulded packaging is in commonly 150 ℃, 4 minutes.
Datasheet : http://www.xlitx.com/datasheet/5161BS.pdf